HUXWRX Flow 22 Ti – 22 LR & Rimfire Calibers – 3D-Printed – Titanium – Full Auto Rated

Description

• Fully 3D-printed in Grade 5 titanium — additive manufacturing is what makes the Flow-Through baffle architecture possible at this weight. No other construction method produces this combination of geometry, strength, and 3.9 oz total weight in a titanium rimfire can
• Patented Flow-Through gas management: the baffle stack is engineered to vent combustion gases forward rather than cycling them back into the action, which reduces blowback to the shooter’s face, keeps the host firearm’s action cleaner, and supports consistent cycling in semi-auto platforms
• No barrel length restrictions across all supported calibers — runs on pistols and rifles regardless of barrel length
• Full-auto rated for sustained fire applications
• Caliber coverage from .22 LR and .22 Mag through .17 HMR and 5.7×28 — one suppressor for the entire rimfire battery plus 5.7
• 1/2×28 direct-thread mount with a recommended installation torque of 125 in-lbf (10 ft-lbf / 12.5 Nm); standard 3/4-inch wrench fits the hex flats
• Cerakote finish withstands temperatures up to 1,800°F for sustained fire durability
• Available in Black or FDE (Flat Dark Earth)
• Limited lifetime warranty from HUXWRX Safety Co. against manufacturing defects and damage from normal use

The Flow 22 Ti requires periodic cleaning. HUXWRX’s recommended cleaning interval is every 500 rounds or when the suppressor reaches 5 oz (142g) total weight — whichever comes first. At its new weight of 3.9 oz (111g), this means cleaning is triggered when the suppressor accumulates approximately 1.1 oz (31g) of carbon and fouling. To remove: index the supplied wrench on the 3/4-inch hex flats and loosen counter-clockwise. HUXWRX recommends HUXWRX Suppressor Sauce as the most efficient maintenance product for performance and service life.